Skip to main content
You find If / else and Wait under Logic in the step list. Neither one needs a connection or counts as an integration step.

Branch with If / else

When a run reaches If / else, the step checks its Conditions. A run that meets them takes the Yes side, and any other run takes the No side. On the canvas, wire a step from the card’s Yes port and another from its No port.
1

Add the step

Under Add a step, select If / else.
2

Set the conditions

In its panel, select Add condition for each condition, then All conditions or Any condition.
3

Wire both sides

Add a step after Yes, and another after No if the other responses need one.
A branch can test the same fields as the trigger’s conditions, plus Inbox status at that moment, which is the response’s status in the inbox when the branch is checked. After a Wait, a branch on that status lets the workflow act only on a response that is still open. A threshold alert has no response behind it, so it can’t use If / else.

Wait before the next step

Wait holds the run for the time you set under Wait for, from 1 minute to 30 days, and then the run continues to the next step. Select 1 hour, 1 day, 3 days or 7 days, or enter a number in Minutes, Hours or Days. The panel shows when a run that reaches the step now continues. A test run doesn’t hold at a Wait, so its result shows Not waited.
Last modified on November 15, 2026